What is our primary use case?
We are responsible for OmniPeek for a company and it is used for WiFi packet sniffing and validation.
We have a protocol to validate the 8.2.11.* IP block. When we are associating a client with the WiFi network, it is following this protocol defined by this IP block. If we have an issue with the new client not associating correctly we have to see why it is happening. For example, it could be the authentication mechanism or the AP not able to respond.
There are legacy features in the solution, such as ABG, then later came ACAC. Whether the rules set out are followed or not by an access point or a client this is what we check by using OmniPeek.
OmniPeek is a standalone solution that is installed on test laptops. It's a multi-license solution.
What is most valuable?
The most valuable feature of OmniPeek is the ability to assign custom color codes to the different packets easily.
What needs improvement?
I am not using OmniPeek for automation, we only do manual testing. Automation testing is tedious to do. The automation should be more user-friendly. I have exposed some APIs but the usage is not user-friendly.
For how long have I used the solution?
I have been using OmniPeek for approximately 10 years.
What do I think about the stability of the solution?
OmniPeek is a stable solution.
What do I think about the scalability of the solution?
OmniPeek is scalable. You have can have a single license but multiple licenses are available. You can install the solution on laptops and servers and the IP can be given to users.
We have approximately 20 testing units and 15 people who use Wireshark as automation analysts and others who use OmniPeek for manual testing.
How are customer service and support?
The support from OmniPeek is good.
You need to know where to look when you are facing issues, and you can click for help. We do not have many issues with the solution because it is user-friendly When we needed to contact the support they were responsive.
Which solution did I use previously and why did I switch?
I have previously used Wireshark. One of the differences between OmniPeek and Wireshark is in the test bed OmniPeek allows you to choose a color coding for each and every component. You can set the color of many components, such as the client based on your interest, and MAC address. You are able to see certain packets from the APs easier. Wireshark is more user-friendly for automation and OmniPeek is good for manual testing.
Wireshark cannot be run continuously because the buffers will be used up after half an hour and the application crash. However, in OmniPeek this does not happen it continuously starts until the memory space is consumed. It will not crash. You can run it for twelve hours continuously and it will save without crashing.
How was the initial setup?
The initial setup of OmniPeek is easy. You download an executable file from the internet, install it, then provide the licensee you were given. Additionally, you can install it on servers, give the IP addresses and it will run it.
What's my experience with pricing, setup cost, and licensing?
There are different types of licenses available.
What other advice do I have?
My advice to others is this solution is easy, but they should have some prior knowledge of how to use a sniffing tool in a network. It will take some time to understand. it. Learning how to use the solution is not difficult.
I rate OmniPeek an eight out of ten.
Which deployment model are you using for this solution?
On-premises